Aube-technologies AUBE NON-PROGRAMMABLE H/C CONTROLLER TH146-N-U Bedienungsanleitung PDF herunterladen

TH146-N-U 1/12

TH146-N-U

Installation Guide

Non-programmable H/C Controller

The TH146-N-U electronic controller can be used with any of the fol-

lowing heating/cooling systems:

The following devices can be connected to the controller:

 air recirculation fan

 humidifier

 dehumidifier or air exchanger

 dual-register meter (dual energy)

 remote control device (for the unoccupied mode)

• CT280-3H3C control module

• TH146 console with two wall anchors and mounting screws

• AC144-03 outdoor temperature sensor (3 m or 10 ft) with mount-

ing clip (see section 2.7)

• RC845 relay (see section 2.4)

• AC146-410 plenum temperature sensor (see section 2.8)

• CT241 telephone controller (see section 2.10)

Configure the control module according to your type of heating/cool-

ing system using DIP switches on the back of the module.

Install the control module near the heating/cooling system, away

from any heat source.

Install the console in a central location. Avoid locations with air

drafts (e.g., top of staircase or air outlet) or stagnant air (behind a

door). Do not install the console on a wall hiding air ducts nor

expose it to direct sunlight.

NOTE: If this controller replaces an old thermostat, any two of the

wires that were connected to the thermostat can be used to connect

the user console to the control module. The maximum wiring length

is 30 m (100 ft).

AC144-03 Outdoor

Temperature Sensor

TH146 User Console

CT280-3H3C Control Module

Removable

Connector *

Removable

Connector *

* To remove a connector from the control module, pry with a screwdriver.

1. Introduction

1.1

Applications

Heat pump

1H1C, 2H1C, 2H2C, 3H1C, 3H2C, 3H3C, 4H2C

HVAC

1H, 2H, 3H, 1C, 2C, 3C, 1H1C, 1H2C, 2H1C, 2H2C,

2H3C, 3H1C, 3H2C, 3H3C

1.2

Supplied Parts

1.3

Accessories

2. Installation

2.1

Control Module (CT280-3H3C)

2.2

User Console (TH146)

Heat pump

HVAC

1 2 3 4 5 6 ... 11 12

Inhaltsverzeichnis

Seite 1 - TH146-N-U

TH146-N-U 1/12TH146-N-UInstallation GuideNon-programmable H/C ControllerThe TH146-N-U electronic contro

Seite 2 - 3.1.3 Keypad Lock (SW1-3)

TH146-N-U 10/12Manual SettingIn manual setting, the user sets the humidity level (5 to 60%).1) Press th

Seite 3

TH146-N-U 11/12

Seite 4 - Wiring Tables

TH146-N-U 12/12Printed in USA 09/2011

Seite 5

TH146-N-U 2/12 Choose a location about 1.5 m (5 ft) above the floor on an inside wall. Loosen the cap

Seite 6

TH146-N-U 3/12With automatic heating/cooling mode changeover, there’s no needto adjust the controller a

Seite 7 - Wiring Diagram: 3H2C HVAC

TH146-N-U 4/12Wiring TablesHeat PumpTerminal Device 1H1C 2H1C 3H1C 2H2C 3H2C 4H2C 3H3CTHConsole Connect

Seite 8 - Configuration Menu

TH146-N-U 5/12Wiring Diagram: 2H1C Heat Pump — New InstallationAC146-410AC144-03CT241HumidifierDehumidi

Seite 9

TH146-N-U 6/12Wiring Diagram: 3H2C Heat Pump — Add-on InstallationAC146-410AC144-03CT241FaultDefrostRev

Seite 10 - 8. Technical Assistance

TH146-N-U 7/12Wiring Diagram: 3H2C HVACAC146-410AC144-03CT241Cooling Unit 1Cooling Unit 2Heating Unit 1

Seite 11

TH146-N-U 8/12Configuration MenuItem HP HVAC Parameters Display Options Default Description1  Tempera

Seite 12 - Printed in USA 09/2011

TH146-N-UUser’s GuideNon-programmable H/C ControllerTH146-N-U 9/12Press the Mode button to place the sy

Kommentare zu diesen Handbüchern

Keine Kommentare

Aube-technologies AUBE NON-PROGRAMMABLE H/C CONTROLLER TH146-N-U Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Schalttafel Aube-technologies AUBE NON-PROGRAMMABLE H/C CONTROLLER TH146-N-U herunter. Aube Technologies AUBE NON-PROGRAMMABLE H/C CONTROLLER TH146-N-U User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schalttafel Aube-technologies AUBE NON-PROGRAMMABLE H/C CONTROLLER TH146-N-U